what g-code delivers 'orientat' for M axis ? pls check attached image
at this position, i can't rotate the tool by hand, thus there is kind of a break; M phase is 300degrees, and when turret is indexing, M phase is changing from 300 to circa 245; i achieved the 'orientat' state by using G296, and the phase angle by editing " system para \ M orient offset ", but the break is delivered by the G296 cycle, not by pure g-code
also, i can not insert g-code after the moment when M axis is oriented ... after G296 executes, there is the G180, and at that moment rpm is restored ?!
kindlyCode:M110 M146 M15 G00 X30 Z2.5 T0505 SB=500 C90 G296 X30 Z-5 C90 K0 F0.567 E2.8 HS=-0.02 G95 (*1) G180 (*2) G00 X30 Z2.5 M12 M109 G00 X500 Z200 T0500 ( i wish to insert code after the moment when M axis reaches ' orientat ' state M axis get 'orientat' during executing line *1 G296 cycle is canceled by G180, and when G180 is executed, rpm is restored i can't insert code between G296 and G180, because it will be interpreted as a new position where G296 should be repeated )