Anybody knows anything about this problem? All LEDs are lit or blink green on all units. No red LED
Hi!
I have such problem. In the morning, I turned on the machine, run all axes to the machine zeros and received the error 2 EMERGENCY STOP. I turned off the machine with the rear switch and turned it on again, but the green button on the control panel did not light up. Found that the 24V 120W power supply unit is not working. Disassembled and repaired the 24V power supply, the green power button on the control panel is now light, but the following alarms remain active:
2 EMERGENCY STOP
3 EMERGENCY STOP
382 SPINDLE POWER CUT MALF.
383 PLC EMERGENCY STOP RELAY FAULT
385 ESTOP SAFETY RELAY FAULT
Please help.
Similar Threads:
- Need Help!- Mazak VTC-30C, Meldas MDS-B - alarm 50
- Mazak VTC 20 B with Mazatrol M-plus control
- Need Help!- Mazak VTC-41 Mazatrol EIA
- Need Help!- Mazak VTC-30C Restart not working
- Need Help!- Mazak VTC-41 with Mazatrol EIA error
Last edited by Foreigner1976; 09-27-2023 at 03:44 AM.
Anybody knows anything about this problem? All LEDs are lit or blink green on all units. No red LED
Problem is solved.
...what was the problem ?
I apologize for the late reply. The reply notification does not work.
In my case it was a software problem. I performed the memory reset procedure, reinitializing memory and all the errors disappeared, the machine works normally.
If you do not know how to do this, then I will try to explain this procedure.
Last edited by Foreigner1976; 11-08-2023 at 06:42 AM.