- okuma lathe prox sensors
-
Registered
okuma lathe prox sensors
I currently operate an Okuma Captain L370M Lathe. The issue is with the chuck jaw proxsimity switch positions. I need to calibrate them. Is there anyone out there with some info for a DIYer ?
Thanks
Similar Threads:
Last edited by ASCENTEC; 11-04-2010 at 03:29 PM.
Reason: misspelling
-
- okuma lathe prox sensors
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules