- Question about Leadshine DM556 Stepper Motor Driver
-
Member
Question about Leadshine DM556 Stepper Motor Driver
Hello, I'm new to forum (and Arduino) so I hope I'm asking this correctly.
Does anyone have any advice/guidance for interfacing a UNO to a Leadshine DM556 driver?
https://www.oyostepper.com/goods-124...per-Motor.html
PDF:https://www.oyostepper.com/images/upload/File/DM556.pdf
I'm planning to use a NEMA 34 motor to drive the Z-axis on small mill. No positioning, just want to control speed and direction.
Regadrs,
JD
Similar Threads:
-
-
Member
Re: Question about Leadshine DM556 Stepper Motor Driver
You can connect the UNO direct to the DM556.
The DM556 has optocoupler inputs that will work direct connected to the UNO.
connect the +5v of the uno to PULL + and DIR +
connect any two digital outputs to PULL - and DIR -
connect your motor and power supply to the DM556
program the Arduino and go for it
- Question about Leadshine DM556 Stepper Motor Driver
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules