- Problem- HITACHI HT25S Z AXIS ISSUE
-
Member
HITACHI HT25S Z AXIS ISSUE
Hello All,
Most of the time when I start up the 1988 Hitachi Seiki lathe with a MULTI Control, I get these Alarms after I press the STAND BY button,
ALARM 392 Z-AXIS TG DISCONNECTED
ALARM 390 SPINDLE TG DISCONNECTED
ALARM310 POWER FOR SERVO NOT SUPPLIED
ALARM 280 NOT READY
The machine fires up sometimes others it goes in to the above alarm states.
Could someone help me with what could cause a intermittent issue I am having.
Thank You Skeney
Similar Threads:
Last edited by SKENEY; 07-15-2013 at 12:39 AM.
-
-
Member
Skeney,
sounds like the power supplies for the control and drives are getting old. Usually, they energize in the time it takes to walk from the main power to the control, and are ready to fire up once you power on the control. When they get older, they take longer to energize so the control becomes "ready" before the axis and spindle drives have fully energized. What kind of spindle / axis drive does it have? Yaskawa?
John
- Problem- HITACHI HT25S Z AXIS ISSUE
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules