Not allowed in state RUN-SUB

[Insect]

Hi,
Now I have this. What is Run-Sub? It happens after one MDI entry of a toolchange effort, then continues each time, as if a subroutine is going on without stopping potentially.
I will revise my macro better tomorrow, incase I have an open loop going on,etc. not sure.

Similar Threads:

• Not allowed in state HW-V, referring to M6 commands
• Problem- Need to know max allowed computer speed to run Mach3
• am i allowed to ask this?
• No laughing allowed...

[Insect]

Resolved:

Eding responded that there was an 'endif' statement missing in my macro, things seem well now.