cnc4pc-mpg-rapid

[AMMO1033]

I installed a cnc4pc 6 axis mpg pendant. using c22 board and matching ribbon cable. Plugged into port 3 of the warp9 ess. I am using mach4. 4.2.0.4612 my problem is when i select any axis it rapids in one direction until i turn off the selected axis. It's also a bit of a delay starting and stopping the rapid. What am I doing wrong? BTW I watched the youtube video. Is there a calibration?

Similar Threads:

• Hard Wire MPG vs usb MPG
• Need Help!- Setting Rapid Feed and Maximum Cutting Feedrate when Z rapid is different than X & Y
• MPG: Can I hook up directly to JP6... MPG is 5vdc logic? Do I need to use Resistors?
• Haas VF4 Rapid Moves vs. CAMWorks Rapid Moves and Post Processor Issues
• CNC4PC MPG pendent + C22 setup

[AMMO1033]

I finally figured it out with help with mach support. There were several items missing from the set-up instruction. It works great now!