still outputting a bunch of straight lines where it should be arcs... ive attached an update of what i have done. you can see them when you run simulation.
unfortunately i dont have a digital copy of the g-code list that i can supply you. we did send one to you when we had our post built. this will have to do for now as i cannot spend any more time on this job.
Jay,
Can you pm me your customer ID?
thank you both for the effort, probably wont hear from me until the new year now. Happy holidays!
Jay,
Just shoot it to me when you get a chance. I hope you have a merry Christmas and a happy new year.
Was there a resolution to this issue? I am seeing the same thing, a bunch of G01 commands instead of G03 with a center part.
I am cutting a variable radius on a cylinder, should just be a bunch of arcs at different depths. Is there a way to tell BobCad " just make them arcs" ?