- Source of HDF
-
Registered
Source of HDF
Hi Gang,
I am from the Edmonton area and was wondering if anyone knows a source of High Density Fibre board. I am going to make a grid based vacuum table for my CNC and am under the impression that MDF is too porous for this purpose.
Thanks in advance.
Dan
Similar Threads:
-
-
Registered
Re: Source of HDF
Hi Dan, don't know if you've found an answer but I have some info for you.
Upper Canada Forest Products
15832 142nd Street
Edmonton, Alberta
Canada T6V 1H9
t: 1 866 265 0624 | 1 780 863 3316
f: 1 780 457 6638
sales_edmonton@ucfp.com
I have a 5 x 10 router table with a vacuum top in the same grid formation. It works great. Although I have it zoned, I can still hold small/medium/large work pieces in place on top of a full 4 x 8 spoilboard without clamping. The vacuum sucks right through my spoilboard. My base is made from UCFP's Medite MDF at 1.5" thick. I had to ensure my vacuum piping was sealed well and the grid patterns were well sealed with a spray sealant (used laquer clearcoat over primer)
Spoilboard is 1/4" thick standard mdf.
I think that UCFP may offer HDF sheets as well if you really are intent on going that direction.
-
Registered
Re: Source of HDF
Also, I use a 1/2hp regen vac made by GAST. It is 32 to 39 Hg
- Source of HDF
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules