Hi mrgame1988,
Thanks for that. I did find this as well, which was a great help. Steppers only go in the one direction though....?
Running Mach3, Smooth Stepper with an Ocean Controls KTA 205 for a breakout board. P1 Step, P2 Direction, P3 COM. on the driver side. Getting the standard 0-5v(depending on the direction) for the direction pins.
Tried hi/low combinations to no avail. It has to be something simple that I'm missing...... surely.
Any idea on the jumpers to the right of the step/dir inputs?
One thing that has me a little perplexed the original break out board (AXYZ AMC 0004G) stocktwits amc
https://codeprozone.com/code/html/14...twits-amc.html, the pinout (P41) diagram suggests Pin1 to be 12v on the BOB, then step (pin 2) and direction (Pin 3), but the stepper motor driver page says 5v+... for pin1?
I really appreciate the help.
Thank you..
A