- Need Help!- Xylotex Board quit working !
-
Registered
Xylotex Board quit working !
I have a 4 axis board that just quit working.??
I purchased a 4 axis kit with 425's from Jeff a couple of years ago and have hooked it up to a small mill. It has worked great and have had no issues with it at all. I have about 20 hrs use on my machine now. Last night I was running a program as normal and the xylotex unit shut down. The light was on in the switch because it was getting AC but the power supply shut down. I disconnected the AC took the box apart right away and nothing was hot, no trace smells of smoke and nothing looks burnt on the driver board. I disconnected 24v Vbb from the driver board, hooked up AC, turned the box on and the power supply and the fans came on.The P.S is putting out 28 v. I test across Vbb and GND in on the board with it disconnected and it is shorted out. I also tried this with the motors disconnected from the driver board and it was still shorted out. If I hook up 24 vdc to Vbb again P.S shuts off again. What is the normal cause of this happening and is there a fix other than buying a new board? The system was under low load meaning the steppers weren't being worked very hard at the time it quit and the xylotex system has very low hours on it. Oh what could it be ??
Kel1
Similar Threads:
Last edited by kel1; 03-28-2009 at 02:19 PM.
-
-
Registered
Maybe a little late but I just had the same thing happen. At first I assumed it was the PSU but after disconnecting the board from the PSU, the power supply was running the proper voltage.
Meanwhile I am tworn if I should invest in another xylotex given it should have lasted longer (3 years) and a 90 day warranty is pretty lame.
Since they do not do board repairs or offer a replacement discount I might as well look for a different cheaper priced board as there are many now available.
-
Registered
Re: Xylotex Board quit working !
I was able to remove the dead chip from the Xylotex board and I now have 3 axis instead of 4.
Obviously had to reset up in Mach 3 and all works fine again !!
Sent from my SM-G900W8 using Tapatalk
- Need Help!- Xylotex Board quit working !
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules