Just change your steps per inch to match. eg 4 inches = 8000 steps so 2000x4/(3/8)=21333.33 steps per inch. Cheers Peter s
I have a Xylotex 3 axis board with 4 wire steppers (Nema23), Mach3, XP Desktop, HP 20.7" flat monitor. When I jog my motors 4 inches, the Mach3 DRO shows 4 inches but actual travel of my mill table is only about 3/8 of an inch. Motor tuning is:
Steps Per - 2000, Velocity 175, Acceleration 25 and the Pulse - 1 and 1.ted. Thank you,
Suggestions appreciated. Thank you,
Ray
Similar Threads:
Just change your steps per inch to match. eg 4 inches = 8000 steps so 2000x4/(3/8)=21333.33 steps per inch. Cheers Peter s
My Xylotex has micro stepping set by jumper. You may want to double check that, otherwise it's a calculation (decimal ?) error.
Last edited by cyclestart; 03-11-2019 at 10:47 AM.
Anyone who says "It only goes together one way" has no imagination.
We're analyzing your site.
tree service Pointe-Claire