Software configuration > Display settings > Dynamic coordinate display. You can set it from 1 decimal to 5 decimals.
Hello!
Relatively new to WorkNC, my measurements are displaying at three decimal places and I would like to change that to four. I've been digging through settings but can't find anything to control that, anyone know where this elusive setting is?
Similar Threads:
- CNC Precision Machining Services-Liang Xin Precision Co., Ltd., Taiwan
- Looking recomendation on precision angle finder and precision squares 20" and above
- REG Precision Metal Arts - located in Massachusetts offering precision machining.
- At Precision Machining Ltd is ready to provide you with the precision components you
- precision servos (digital) vs. precision stepper (<3.6degree step angle)
Software configuration > Display settings > Dynamic coordinate display. You can set it from 1 decimal to 5 decimals.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)