I saw somewhere I can't remember if it was on here or you tube about using some type of brad / nails that are made out of nylon or plastic so in the chance your router bit would hit it the fastener would be cut and not damage the bit.
Any help is appreciated
Similar Threads:
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Yup that's it. Thanks