Assuming your cutting wood, try 12,000-14,000 rpm, and 100-150ipm.
HI. I am considering using a 1" (25.4mm) roundover bit - without the bearing, see photo.
For feeds & speeds how should I think of it? V-bit, End mill, form bit?
In ferreting out info from various sites the speeds & feeds are frightening to me .
Any advice appreciated.
Thanks.
Similar Threads:
Assuming your cutting wood, try 12,000-14,000 rpm, and 100-150ipm.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks.