I just registered for CNCzone. Really cool! I have a Phoenix Magnum wood lathe and want to start running production on it. I had a floppy with the software at some point, cant find it now. Does anyone have the software or good info on running something else to make it go. The geometry for the job is very simple-just need to interface with the machine to make it go. Also, I have the books and other info for that machine. It seems that people cant find support since the company went out of bis.
Also, this is my first thread started-any tips on using the site?? Where can I find a swiss/Citizen forum??
That would be great. I really, really need to get that machine online. I am just about to send it to auction if I can't get it going. After I get it running, I would be very interested in how you converted to G-code.
You really found it?? That is really cool. I have been looking for a long time without much luck. Can I please have a copy of it?? I would appreciate it very much. If you could email me a copy or, I could pay the shipping if you would send it to me. Completely your choice. My employer was gonna auction that lathe because he couldn't find the software---I have been wanting to be back full-time and getting that lathe running will certainly help with that. Thanks again,
I got my Lathe setup finally. Actually Forestscientific.com did it for me for a small fee. They had the origional software for the lathe and were very helpful with the install. I dealt with John and he was really great. They also carry some parts for the lathe. I didnt have to upgrade anything and there software worked in windows. This is a great site and thanks for the help.
Just wondering if the manual and floppy are still floating around out there. I just picked up one of these lathes and would like to get it going but I don’t want to spend a fortune on software and setup.