If you command the B axis to zero, then command B360, does it execute 1 revolution? If not then your steps/unit are incorrect
What type of axis is the B defined as in the INI?
Are you using a Rotary Wrapped post processor in Aspire? Which one?
Today, while running a test piece on my rotary axis using Aspire 9.510 and Wincnc, I was making a rounding tool path on a 4X4 post. I set the Rounding Tool project up as per the Vectric instructions, and the machine worked well. However, instead of the (for my machine) B-axis turning 360º per cut, it was turning 360" per cut (that's 35 revolutions)! What am I doing wrong? Is this something in the post processor that needs to be corrected? Is it a setting in the G-code? If I can get the B-axis to recognize degrees instead of inches, I think things will work great! Any ideas?
Steve Weaver
newbe
Similar Threads:
If you command the B axis to zero, then command B360, does it execute 1 revolution? If not then your steps/unit are incorrect
What type of axis is the B defined as in the INI?
Are you using a Rotary Wrapped post processor in Aspire? Which one?
Gary Campbell GCnC Control
Servo Control & ATC Retrofits
1.- Okay! When I input B360 the B-axis turned 360 inches (that is, Approximately 35 revolutions.
2.- This is the only settings for B-axis I find in the INI
[B Axis]
axisspec=p0 s4 d4 r2000 a2200 o0 t4
axisvel=r1500 f300 s150 m500 h1500
3.- I'm using WinCNC Rotary X9*.tap)
The "r" parameter on the axis spec line is the issue. It needs to be set to steps per degree. to arrive at the correct number you will calculate as follows:
Motor steps per rev * reduction ratio / 360
Gary Campbell GCnC Control
Servo Control & ATC Retrofits
Thank you so much!
Steve Weaver
These are the figures of the motor/gearbox:
Neugart PLS70--- 1=10
F-Nr 2040332 - 1 -008
OP .UN. 02/2009
If any of these make sense to you.
I'm very new at this so I'm not sure how to find the steps-per revolution or the reduction ratio.
Those are not really numbers that jump off the page as definitive, but assuming your motor is a common 200 steps per rev, here are the numbers that you can pick from to match the settings on the drive.
Gary Campbell GCnC Control
Servo Control & ATC Retrofits
Thanks!
Steve
We use inches for degrees, not centimeters. The reason is that it is easier to do calculations in inches and then you can check https://www.buybestcertificate.com/ and convert them to degrees. It's normal for the axis of a rotary axis to be oriented in degrees, as opposed to radians. The reason for this is that rotary motion requires an angle, and an angle requires a point at which to make the measurement.