- Newbie- Rotary axis speed control
-
Member
Rotary axis speed control
Thanks to Mike Queen at WinCnc, I've got my rotary axis (B-axis on my machine) working. My machine, an Automated Precision Equipment 200HD has the rotary on the far right about 5" off the spoil board. The rotary is parallel with Y-axis, and wraps X-axis. I'm working in Vectric Aspire 9.510, I was noticing that when I cut a profile the B-axis would revolve 35 times before the Y-axis would advance the tool. Seems like a lot of wasted time. I ran an "Optimized Raster" for rounding the square stock, and then started my profile cut. Any thoughts? Do I have to go into my Wincnc.ini file and change the B-axis settings (hope not, I'm not that savvy with the post processor software)? By the way, I was running 3-D Raster Along X.
Thanks!
Steve Weaver
Similar Threads:
-
- Newbie- Rotary axis speed control
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules