- Problem - WinCNC Plasma restart
-
Registered
Problem - WinCNC Plasma restart
Hi all,
I have a customer that has WinCNC on his Hidef Plasma cutter, It works very well but has one small problem....
If they lose the arc and have to restart, the torch first goes up to the top limit and then as it goes down to the plate it starts to strike all the way until it touches the plate. Is there any way to delay the start signal or only make it strike when it reaches a certain Z position, as the high frequency eventually damages the THC?
Thank you in advance :-)
Regards
Steve
Similar Threads:
-
-
Registered
Re: Problem - WinCNC Plasma restart
look through the wincnc file, and look for the calls to the macros used to start the torch, the control code should be there some where, make sure you save the original if you try any changes, the same goes for any macros you might try to adjust.
- Problem - WinCNC Plasma restart
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules