- HSK Tooling Wont release
-
Member
HSK Tooling Wont release
Hi Guys,
I have a Fimec ES929 HSK 63 spindle with less than 100 hours use which I allowed to bottom out on some MDF for a couple of minutes.
When I removed the slightly discoloured tool holder and cleaned it up there was a bit of greasy residue in the bottom the tool holder cavity which I hadn't noticed before
I tried to clean out and cool the lower end of the spindle- yeah I know now a dumb- to ensure the bearings were OK.
Since then I have inserted another tool only to have it seize up in the Spindle nose.
So far not wanting to damage anything with the knochrometer I have dismantled as much of spindle as I can but still can't dislodge the tool holder
Any suggestions would be greatly appreciated in an effort to remove the Tool holder and prevent any furthe issues .
Pete
Similar Threads:
-
-
Member
Re: HSK Tooling Wont release
This happened to mine. Wood pitch built up. The solution was the knockulator. I held in the tool change button and GENTLY tapped the holder. It popped out with a vengence. Put a pad or some other way to catch it.
- HSK Tooling Wont release
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules