Anyone have experience running gas shielded flux core without gas?


Results 1 to 2 of 2

Thread: Anyone have experience running gas shielded flux core without gas?

  1. #1
    Member DarrellCurry's Avatar
    Join Date
    Apr 2019
    Posts
    3
    Downloads
    0
    Uploads
    0

    Default Anyone have experience running gas shielded flux core without gas?

    I've got a 33-pound spool of flux core that requires gas shielding and no gas. I'm running it in a miller 250x. I've ran a couple of beads with it and it seems to have good penetration and the beads don't look half bad. Any input on this would be appreciated.

    Similar Threads:


  2. #2
    Community Moderator Jim Dawson's Avatar
    Join Date
    Dec 2013
    Posts
    5717
    Downloads
    0
    Uploads
    0

    Default Re: Anyone have experience running gas shielded flux core without gas?

    I guess if you're happy with the result and it's a non-critical application, then go for it.

    Jim Dawson
    Sandy, Oregon, USA


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Anyone have experience running gas shielded flux core without gas?

Anyone have experience running gas shielded flux core without gas?