Need Help! 20CrMnTi welding shaft build up


Results 1 to 2 of 2

Thread: 20CrMnTi welding shaft build up

  1. #1
    Member
    Join Date
    Mar 2013
    Location
    US
    Posts
    33
    Downloads
    1
    Uploads
    0

    Question 20CrMnTi welding shaft build up

    Hi guys !

    I need to build up a splined shaft from 52mm(top of spline is 60mm) up to 70mm O.D over a length of about 110mm then, anneal it, bore it 50mm I.D, turn it, carburize it, heat treat it and grind it for a bearing fit... 20CrMnTi Material is close to SAE3115 or 20MnCr5.

    I have an AC stick welder and my welding buddy is a TIG welder by trade..

    What welding/filler rod should I use for this job ?

    Thanks very much !

    Similar Threads:
    Last edited by bmn; 01-31-2020 at 12:02 PM.


  2. #2
    Member
    Join Date
    Mar 2013
    Location
    US
    Posts
    33
    Downloads
    1
    Uploads
    0

    Default Re: 20CrMnTi welding shaft build up

    Up !!!



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

20CrMnTi welding shaft build up

20CrMnTi welding shaft build up

20CrMnTi welding shaft build up