- Need Help!- 20CrMnTi welding shaft build up
-
Member
20CrMnTi welding shaft build up
Hi guys !
I need to build up a splined shaft from 52mm(top of spline is 60mm) up to 70mm O.D over a length of about 110mm then, anneal it, bore it 50mm I.D, turn it, carburize it, heat treat it and grind it for a bearing fit... 20CrMnTi Material is close to SAE3115 or 20MnCr5.
I have an AC stick welder and my welding buddy is a TIG welder by trade..
What welding/filler rod should I use for this job ?
Thanks very much !
Similar Threads:
Last edited by bmn; 01-31-2020 at 11:02 AM.
-
-
Member
Re: 20CrMnTi welding shaft build up
- Need Help!- 20CrMnTi welding shaft build up
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules