- welder wire feeder
-
Member
welder wire feeder
Hello, I was hoping someone could give me some feedback on whether or not it would be necessary to insulate the shaft of a stepper/servo being used as a wire feed for a high frequency pilot Arc start plasma arc welder. I'm concerned about the high frequency high voltage arcing across the rotor and stator and frying out the drive.
Any help is greatly appreciated!
Similar Threads:
-
-
Registered
Re: welder wire feeder
Hello there,
You should insulate the shaft!
Leaving it without insulation leaves you at risk of electric shocks or worse still electrocution. Please do insulate it
- welder wire feeder
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules