welder wire feeder


Results 1 to 2 of 2

Thread: welder wire feeder

  1. #1

    Default welder wire feeder

    Hello, I was hoping someone could give me some feedback on whether or not it would be necessary to insulate the shaft of a stepper/servo being used as a wire feed for a high frequency pilot Arc start plasma arc welder. I'm concerned about the high frequency high voltage arcing across the rotor and stator and frying out the drive.
    Any help is greatly appreciated!

    Similar Threads:


  2. #2
    Registered
    Join Date
    Jun 2018
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default Re: welder wire feeder

    Hello there,
    You should insulate the shaft!
    Leaving it without insulation leaves you at risk of electric shocks or worse still electrocution. Please do insulate it



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

welder wire feeder

welder wire feeder