Something that big won't be cheap.
PS-15N56 - 1500W 56V Power Supply - AnTek Products Corp
Any one have a suggestion for an inexpensive power supply.
I would like a 48 volt through 60 volt 30 amp or so.
Thanks
Similar Threads:
- Will this Stepper Motor and Power Supply be enough with my Lead Screws?
- 48v 10a Power Supply (120v) & 20ft. 4 lead 18awg shielded cable...
- CNC Power supply, good to know !
- $1 New 48V 7.3A Regulated Power Supply & 20Ft 4 lead Shielded cable & E-Stop Switch
- Where to buy a good power supply for gecko 201's
Something that big won't be cheap.
PS-15N56 - 1500W 56V Power Supply - AnTek Products Corp
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks for the tip,
As you well know, Unregulated Power Supplies can momentarily go beyond their rated output. These claim 200% for a few minutes. This will allow for a smaller one to be used. These Tecnik Servos can peak at 12.5 amps each.
This one will work in those conditions.
PS-10N56 - 1000W 56V Power Supply - AnTek Products Corp
Plus, what are the odds that all three motors will go into overload at the same time?