I desperately need some help setting up a viper250 servo driver

Results 1 to 2 of 2

Thread: I desperately need some help setting up a viper250 servo driver

  1. #1
    Registered
    Join Date
    May 2005
    Location
    usa
    Posts
    13
    Downloads
    0
    Uploads
    0

    Default I desperately need some help setting up a viper250 servo driver

    I just got the board and I'm in way over my head. I have the manual for the Viper 200 downloaded from the website but I'm to dumb to figure it out. My first question is were should I put the jumpers? The manual has diagram showing 5 pairs of jumper pins my board only has 3 pair.
    Is there a way to load the settings from one of the other Viper 200 boards on the machine, which seem to be working?
    Any help would be greatly appreciated.

    Similar Threads:


  2. #2
    Registered
    Join Date
    Feb 2008
    Location
    Canada
    Posts
    42
    Downloads
    0
    Uploads
    0

    Default Re: I desperately need some help setting up a viper250 servo driver

    Quote Originally Posted by skypilot View Post
    I just got the board and I'm in way over my head. I have the manual for the Viper 200 downloaded from the website but I'm to dumb to figure it out. My first question is were should I put the jumpers? The manual has diagram showing 5 pairs of jumper pins my board only has 3 pair.
    Is there a way to load the settings from one of the other Viper 200 boards on the machine, which seem to be working?
    Any help would be greatly appreciated.
    I know this is an old posting, but certainly a valid question.

    I too own a 250 which I will be dropping into a retrofit. Here is Larry's response to the question:

    The bottom 2 are step multiplier same as V200. the top one isn't used.
    The drive only has 1 bank.( not 3 like older V200F)

    Just an FYI for those who will be purchasing this product in the future.

    Mark

    Need a Supermax YCM-40 Mill manual? Download the PDF here (replace _ with .):
    [url]http://www.istonline.ca/download/supermax-ycm-40.pdf[/url]


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

I desperately need some help setting up a viper250 servo driver

I desperately need some help setting up a viper250 servo driver