Are there any error messages?
Hey guys, this is my first issue with my biesse klever that I can't seem to solve. I cut cabinet parts mostly, and quite often the spindle will start but then shut down before it starts cutting. I then have to reset it once or twice before it will continue to run and cut the sheet. The weird thing is, this problem never occurs when the line boring heard drills first. If the boring head goes first, it does its job, and the spindle follows with absolutely zero problems. Please let me know what you all think.
Thanks
Abe
Similar Threads:
Are there any error messages?
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Yes there are actually errors. Not always the same error though. Here they are, "PLC9007 Slot reset required" "INV283 Inverter not ready" "INV284 Speed out of safety range". Hope that makes sense to somebody out there.
Abe
Last edited by abewall; 02-10-2018 at 09:14 AM.
Slot reset means you need to bring the dust skirt up,,,,(Stop reset clear)
INV250-290 error range,,,,to fix this,,,grab the gantry ball screw and manually move the head in manual mode..
Keysoftwareservice.com
there was a service call i did where the ground boot was loose,,,,that caused a bunch on inverter errors
Keysoftwareservice.com