I have the lower receiver in the pictures however the matching upper receiver was discontinued and is unavailable. I have purchased the ‘base’ model of the upper receiver (CMT UPUR-1) and am looking to have it milled to match the lower as in the picture. The hex pattern is on both sides of the receivers. The material is 7075 T6 aluminum. I do not have CAD designs for either upper or lower receiver.
I only need the mill work, I do not need the receiver to be refinished, Bare aluminum is fine.
No licensed is required to ship or receive the upper receiver however if you would require the lower receiver as well to take measurements and ensure the upper is milled to match, the lower would have to be mailed to an FFL. I am a licensed FFL in north Dallas so I can deliver the receivers if you’re in the area or ship/receive the receivers directly if not.
I don’t know a lot about machining so please let me know if I left out any pertinent information needed for a quote.
Edit - the pictures don’t seem to posting in very high quality, the pics I have are good quality and show decent detail, I can email them to you if you’d like to see them prior to quoting.
Simple Firearm Machining
Posting Permissions
