Hello guys,
I have Hitachi seiki hs500. In machine right now I can see only 3 axis (xyz) in controller. But 4th b axis module as well as motor also mounted in machine.
Can any one help me how to enable 4th axis in hitachi seiki hs500?
I have just got a old Hitachi VM40 with siecos mark II controller. When i power up the machine, i got alarm "battery alarm ---- please change", i change the battery when machine power up, but i can reset this alarm. Can someone help me???
Hello guys,
I have Hitachi seiki hs500. In machine right now I can see only 3 axis (xyz) in controller. But 4th b axis module as well as motor also mounted in machine.
Can any one help me how to enable 4th axis in hitachi seiki hs500?
Hello
did you get this sorted - its an easy fix but not very upfront - let me know and Ill help you out!
John
Hi, can you send me the procedure to reset the turret of a TS15 seicos 21L
victorsalasgavia@gmail.com
Hello, I have a Mori Seiki VA 35 with FANUC 11 M. I need plc parameters, timers, keep relay, counters and data.
mariocompagnoni1234@gmail.com
Hai There,
We are facing Hitachi seiki C Axis alarm, any way we are not using that axis so if you have C axis Bypass parameter kindly send me maintenance@spe.ie
Hai Hitachi Man
We have HS CS 25 Machine with SEICOS 21L, Now we faced C axis Problem but we are not using that C axis(Spindle act as a C axis). I request you to kindly send me the procedure for C axis By pass.
My mail id is maintenance@spe.ie
Thanks in Advance.
Hai All,
Kindly support me.
OEM : Hitachiseiki
NC: SEICOS 21 L
Required: C axis By pass Parameter.
(Spindle act as a C axis)
My mail id: maintenance@spe.ie
Any service available for Hcut 203 EDM?
I have a hitachi seiki Hicell CA20. Great little machine. Tonight I had a live tool dismount from the turret whilst cutting, probably went blunt and too much side load. Anyway, now the turret live tooling coupling is misaligned. it engages / disengages fine. just not where it should be to load and unload the tools wit ATC. It's like it's jumped a tooth or 2 on the belt. I have never seen this before, so not sure where to look. Books have zero info on this. I can only assume there is a proximity switch somewhere with a dog to locate the orient for engaging. Any help appreciated.
Hi Hitachi Seiki_Man
My name is Michal I'm from Poland.
I have a Hitachi Seiki HT20R. The problem is with the main motor yaskawa drive. There are no errors after the machine is started and referenced. When I try to set RPM in YOG mode, the load meter goes to 110% on the Yaskawa panel, the RUN indicator lights up but the engine is stopped. Can you somehow help ??
Best regards Micha?
pudiste comunicarte con jhon?
necesito ayuda o soporte tengo un VA - 45 errores led en placa C mayuscula / c minuscula / F mayuscula si podes ayudarme seria genial
Send me a pic of the alarm, sounds like you are saying its CcF?
I have a Hitachi Lathe HT 20RIII with a Seicos Multi control throwing a flash Error intermittently upon start up. Seems to be getting worse every day. I can usually reboot it a few time and it will start. Any suggestions I cant find anyone that seems to know these machines anymore.
Ryan