Need Help! YAM Ck ? from 1991 Turret issue when changing tools


Results 1 to 2 of 2

Thread: YAM Ck ? from 1991 Turret issue when changing tools

  1. #1
    Member tomkoz's Avatar
    Join Date
    Feb 2021
    Posts
    8
    Downloads
    0
    Uploads
    0

    Default YAM Ck ? from 1991 Turret issue when changing tools

    Hi

    We have a Yam Ck from 1991 i think, dont know if its 1 2 3 etc since we dont have any numbers on it. It uses Fanuc t15.

    I was using the machine after just sitting for 1-2 years. When i was making a measure cut i pressed on the wrong button and activated the turrent. Changing tool while cutting I hit the emergency button and stopped the machine. i was smoking from the tool holder and i destroyed the tool.

    After that the machine have problems changing tools.

    If i turn the turrent by pressing the button it goes round and it stops like it should, then the turrent goes back into position and then it starts to beep. The turrent looks like its on the correct place and if i shut down the hydraulic and start it again the alarm is gone.

    I can't see any damages on the turrent.

    Is it a senor for position

    I dont have any drawing on the electrics or mechanics on the machine. Only on fanuc system and parameter

    BTW the seller told me that yam is a copy of mori seki. is this correct.

    best regards

    Similar Threads:


  2. #2
    Member tomkoz's Avatar
    Join Date
    Feb 2021
    Posts
    8
    Downloads
    0
    Uploads
    0

    Default Re: YAM Ck ? from 1991 Turret issue when changing tools

    Problem Solved

    When I hit the emergency button the revolver was unclamped prepared for changing tool. The revolver got stuck in the part while the gearbox was moving. After restarting the machine the revolver went back to clamp posision but not on the right spot. It was between gears.

    So now we tried to change the tool and when it went out to unclamp position we hit the emergency button and then i could move the revolver 1 step back to the right position. then i restarted the machine and it wored





Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

YAM Ck ? from 1991 Turret issue when changing tools

YAM Ck ? from 1991 Turret issue when changing tools

YAM Ck ? from 1991 Turret issue when changing tools