I've searched up and down and can't find the answers i'm looking for so i've resorted to asking.
I have a 1992 matsuura with an i80. When I try to use g54 with it, it alarms out and says unusable code. Is that not a purchased option or is that just a setting? I've been reading the manual and it shows to use g54 so i'm confused to how it won't work. Do I have to use an alternate code? I've read some about G92 but am not very clear on it.
I have figured out the control doesn't show a g54 offset page, the only offset page is just a workshift offset, and then the machine coordinates located on it.
Is there a setting or parameter to active this page so I can program with G54??
Help? Anyone? Lol
Last edited by horton_cody; 06-28-2018 at 08:15 PM.