Hello,

Hopefully this is in the right section and I apologize if it is not.

I have a Techno-Isel Davinci Stepper CNC router that I would like to control using matlab. I would like to continually feed commands to the Davinci in a loop using matlab. I don't know very much about the CNC, but I assume this might be achievable using Serial communication? I am able to establish a serial connection with the Davinci in matlab, but I am unable to get it to move at all. I'm not sure what to write to the serial in order to get it moving. Is what I am trying to do possible? And if so, what would I have to write to the serial in order to get the Davinci moving? Thanks.

Similar Threads: