I've purchased my CamBam license and waiting for the licence code to come through, but in the meantime I have been playing with it and using the points to generate the drilling positions now that I'm more accustomed to Qcad (which I have to say I am liking more and more, apart from a couple of minor issues).
If you look at the CamBam screenshot, you can see that CamBam appears to be locating the holes via the points and allocating a toolpath accordingly. The left side of the screen are the settings I am using to produce the gcode. However the out put generates what you see in the UGS visualisation screen (second screenshot), which as you can see bears no resemblance to the original. I tried to run it just in case the visualisation was wrong, but it is just garbage, errors at every line. I've included the .cb file used to generate the .nc file. This was produced on a different PC to before to make sure it wasn't an issue with the CamBam installation
What am I doing wrong?
****Edit****
Received the license, tried it again with the same results, so it must be something wrong with my file or setup
Cheers
Les