Scan a metal part with flat bed scanner into CAD program

[matridium]

Does anyone have experience doing this?

I have a flat part with 5 holes in it it has lots of curves and instead of trying to use an edge finder and finding lots of points and entering them into a CAD software and interpolating lines is it possible to just use a flat bed scanner to scan the part and then convert it into a DXF?

Thanks in advanced.

Mike

Similar Threads:

• Build cnc router without linear ball bearings ?? Flat metal on flat metal with lube ?
• Controlling a stepper morot from flat bed scanner
• Rolling a flat sheet metal part.
• Scan into CAD program recomendations??
• scan part and generate cad code?

[vicpaulsen]

Yes that is very possible. I have done this but lay down two rules in the x and y axis to use as calibration guages. You can import the resulting image into your cad program and then create the various lined. arcs and circles.
I've use this technique to create flat gasket patterns from castings and it has worked very well.

[matridium]

Yes that is very possible. I have done this but lay down two rules in the x and y axis to use as calibration guages. You can import the resulting image into your cad program and then create the various lined. arcs and circles.
I've use this technique to create flat gasket patterns from castings and it has worked very well.

ok so if I use just two steel rules one in the x and one in the y I can use them to calibrate the image? I guess just trace the part with the drawing elements in Auto cad?

Best
Mike

[vicpaulsen]

Yes that is exactly what I have done. What CAD software are you using?

[routalot]

Is this of any help?Good luck with Inkscape as I find it the least intuitive piece of software ever devised.