- step file
-
Registered
step file
Hello,
After loaded step or igs file into CAM module, I can't do anything with model.
Why can't I work with step or igs files in CAM module?
Best Regards
Amnon
Similar Threads:
-
-
Member
Re: step file
We need more information about what is happening. When you say you can't work with the model, what is the problem?
-
Member
Re: step file
Try doing a Wave link from the model and hide the original, this will allow you to select keypoints and apply Synchronous operations. Or, it could be the geometry came in as non-solid. See link for a discussion on the forum.
-
Member
Re: step file
bnagel made a good point. Make sure sure your selection filter is set properly.
-
Registered
Re: step file
Thank's a lot ...... filter......mmmm what a stupid mistake.
Respect
Amnon
- step file
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules