step file


Results 1 to 5 of 5

Thread: step file

  1. #1
    Registered
    Join Date
    Sep 2011
    Location
    Poland
    Posts
    21
    Downloads
    0
    Uploads
    0

    Default step file

    Hello,

    After loaded step or igs file into CAM module, I can't do anything with model.
    Why can't I work with step or igs files in CAM module?

    Best Regards
    Amnon

    Similar Threads:


  2. #2
    Member 1 Infinite Loop's Avatar
    Join Date
    Sep 2009
    Location
    U.S.A.
    Posts
    78
    Downloads
    0
    Uploads
    0

    Default Re: step file

    We need more information about what is happening. When you say you can't work with the model, what is the problem?

    NX series 1926, v1942


  3. #3

    Default Re: step file

    Try doing a Wave link from the model and hide the original, this will allow you to select keypoints and apply Synchronous operations. Or, it could be the geometry came in as non-solid. See link for a discussion on the forum.



  4. #4
    Member 1 Infinite Loop's Avatar
    Join Date
    Sep 2009
    Location
    U.S.A.
    Posts
    78
    Downloads
    0
    Uploads
    0

    Default Re: step file

    bnagel made a good point. Make sure sure your selection filter is set properly.

    NX series 1926, v1942


  5. #5
    Registered
    Join Date
    Sep 2011
    Location
    Poland
    Posts
    21
    Downloads
    0
    Uploads
    0

    Default Re: step file

    Thank's a lot ...... filter......mmmm what a stupid mistake.

    Respect
    Amnon



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

step file

step file