I think you are asking about point density, not distribution.
Reducing the intol and outtol tolerance values, and setting the motion output to linear, should increase the number of points.
hi guys
i have a question about point distribution
how can I decrease or increase the distance between two points in my extracted G-code ?
imagine that all the operations are ready and now it's the time to get the G-code and you put the machine on linear movments , means you won't have any G2 or G3
clearly I would end up with a G-code full of G1 movements and the only thing I want is i want this code with more lines and points . closer points
how can I do that ?
thank you in advance
Similar Threads:
- Lasercut 5.3 start point and end point not matched and curve line not smooth?
- Looking for distribution?
- why the laser not line up (cutting original point does not meet end point)
- Problem- Fanuc 18i-TB absolute motor pulscoder zero point shifts itself (floating zero point)
- Holzher Holz-Her speedy 207 woodworking CNC point to point boring machine router
I think you are asking about point density, not distribution.
Reducing the intol and outtol tolerance values, and setting the motion output to linear, should increase the number of points.
Mark Rief
Siemens PLM
Greattt. Thanks a million
It was a big help coz our machine had problems with g2 and g3 and the controler wasn't meant to be for turning
I actually I have written some parametric codes for the curve parts but we needed sth more reliable
Thanks again
Sent from my iPhone using Tapatalk