- Stepper Motors don't turn after relocating PC
-
Member
Stepper Motors don't turn after relocating PC
I am a newbie CNCer and I am still trying to configure my machine.
My problem is that I relocated to PC to a more convenient location and thought I would incorporate my docking station at the same time.
since then none of the motors will run.
I have taken the dock out of the system (although the PC drivers are still installed) but still the motors don't turn
I checked the network settings both PC and motion controller - all good, Power is getting to all the components as well.
I checked all the axis settings in UCCNC again all good.
so now I am stumped
my system is this:
UCCNC software
C35S breakout board
UC300eth-5LPT motion controller
3 axis - 4 motor (A slaved to Y)
If anyone cal help I would be grateful
Paul
Similar Threads:
-
- Stepper Motors don't turn after relocating PC
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules