Stepcraft 840 stuck axis limit switch UCCNC issue

Results 1 to 1 of 1

Thread: Stepcraft 840 stuck axis limit switch UCCNC issue

  1. #1
    Member
    Join Date
    Aug 2017
    Posts
    31
    Downloads
    0
    Uploads
    0

    Default Stepcraft 840 stuck axis limit switch UCCNC issue

    Hi,
    I have a Stepcraft-840 which is giving me trouble.
    I tried to home the axes.

    Y is homed ok.
    After I home X, and try to run it at 50% speed to the end of the axis, just to see if it goes back and forth okay, it gets stuck in the middle.

    I've triple checked every possible thing I could, including electrical wiring, bolts etc.

    The attached is the diagnostics page and error.

    Anyone have an idea what I could do?

    Thank you!

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Stepcraft 840 stuck axis limit switch UCCNC issue-1-jpg   Stepcraft 840 stuck axis limit switch UCCNC issue-2-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Stepcraft 840 stuck axis limit switch UCCNC issue

Stepcraft 840 stuck axis limit switch UCCNC issue

Stepcraft 840 stuck axis limit switch UCCNC issue