There is no lathe mode, but some people have used it for lathes.
UCCNC currently only supports one MPG.
Good morning all,
I looked over the website and even the DOCs but still not sure (perhaps because I want this)...
Is the UCC software able to control lathes?
Can two MPGs be used at the same time with the UCC software?
Thanks
Chris
Similar Threads:
There is no lathe mode, but some people have used it for lathes.
UCCNC currently only supports one MPG.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks Gerry,
I was afraid of that. I guess it is time to look into LinuxCNC.
Chris D