- UB1 + UC300ETH wiring
-
Member
Re: UB1 + UC300ETH wiring
Thanks Ralph & Gerry,
good info there. I've been using the Neuron Lite for a little while now, and have ordered the UB1 a few days ago.
It's quite clear how questions that appear very unconnected with UCCNC or the UC300ETH can end up with chat that is very connected. At the end of the day the UB1 is a product dedicated to the UC300ETH so I'd think seemingly unrelated question would be of interest to UC300ETH users, even if they haven't got a UB1 board. Such threads may lead to them buying a UB1 board for their UC300ETH.
Keith.
-
-
Member
Re: UB1 + UC300ETH wiring
Keith,
Hope my little blurb helps out a bit. Give me a shout if you run in to problems switching over to the UB1.
Not that I'm an expert - we haven't got the machine torch yet so we're just driving the table around making BUZZ BUZZ noises and cutting water table panels by hand.
I'll be switching my mill from a UC400 to a UC300/UB1 combo this winter, so there's more 'fun' in my future.
-R
-
Member
Re: UB1 + UC300ETH wiring
Thanks Ralph, much appreciated.
My plasma is running with a UC400 at present and I'd like a few more inputs for UCCNC "Trigger Inputs". Who knows, I may find a use for the analogue inputs at some point.
Recieved the UB1 yesterday, took only 3 days to receive it via DHL.
Took a while to get used to the Neuron On/Off switch in addition to Cycle Start / Stop, and I was always leaving it on when it needed to be turned off.
Keith.
- UB1 + UC300ETH wiring
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules