There is no port address in UCCNC. It connects directly to CNC Drive motion controllers. If you are trying to use UCCNC with a parallel port, it can't. It doesn't use parallel ports.
New to UCCNC. I have been using Mach3 for a while but the erratic nature of it is costing me too much. I cannot get UCCNC to communicate to my controller and I expect the issue is setting the Port Address. In order to get Mach3 working with my pc and controller I had to manually set the Port Address since, despite being LPT1, the actual address for the port is not the usual.
Is there a method to correct this in UCCNC?
Similar Threads:
There is no port address in UCCNC. It connects directly to CNC Drive motion controllers. If you are trying to use UCCNC with a parallel port, it can't. It doesn't use parallel ports.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)