Hi All,
Yes, I made further progress. Pictures below shows the new version under testing.
It corrects few mistakes from last time which were.
-CP logic >> Now the user can cancel CP function from K5 relay and able to use it as normal on/off relay
-Relay orientation >> Now, the orientation same as UB1 motherboard.
-Output logic not correct during initial time when using with 5LPT product >> The new design has 2 mode: UB1 and 5LPT.
The UD1 comes in 2 versions: The universal input type (U-Type) and the NPN input type (N-type). The U-type able to handle variety of input types including DC voltage source (PNP) and sink (NPN), at 5V and 24V. It can be used with AC input as well. On the other hand, The N-Type is limit to use with sink (NPN) at 5V and 24V volt level Only.
I need more few days to test the new design. If all goes well, I should have product already for sale within 6 weeks.
So, Now I need to make a manual by getting help from Gerry.
I also need to make new testing tool because the new design, the input can be both NPN and PNP. One input need to be tested twice.
Thanks,
Weerasak
2018-03-04_03-32-18 by Weerasak Kanjanarait, on Flickr
2018-03-04_03-32-43 by Weerasak Kanjanarait, on Flickr