Anyone please?
Hi all,
Im using UC100 with UCCNC. When I make parts (aluminum) the surface finish is not that good (i see like ripples) in the acceleration regions. Slow acceleration kinda solve the problem. I usually do Roughing with high acceleration and finishing with slow acceleration. Is there anyway to add a M-code or something in the Gcode file to change the acceleration automatically for roughing and finishing passes?
Thanks.
Similar Threads:
Anyone please?
If you asked over at teh UCCNC website you may get a bit of help.
(;-) TP
Not that I'm aware of.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
You are not teh only one that has asked for that. Yes it can be done.
(;-)TP
My opinion is when you use a low accelaeration then you are not cutting enouph material . In the start your feed is to low .. and you are not cutting at all, so i think you have te speed up. and try constand velocety.