Problem Part , slice or section a 3D part


Results 1 to 3 of 3

Thread: Part , slice or section a 3D part

  1. #1
    Registered
    Join Date
    Nov 2004
    Location
    USA
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default Part , slice or section a 3D part

    Using bobcad v28 and cannot find a way to break apart a 3D object. I have a part that is too big to 3D print so I need to break it apart into 4 sections. There must be a way to do this. If not, I could draw the part into 4 sections but I then cannot figure out how to bevel only the outside edge of a circle.

    I used the extrude boss and draft angle to build the complete circle but I cannot bevel the outside edge when it is in quarters?

    Anybody that can point me in the right direction?

    Joe L.

    Similar Threads:


  2. #2
    Registered
    Join Date
    Nov 2004
    Location
    USA
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default Re: Part , slice or section a 3D part

    I got it! I finally found out how to work the solids-split commands and got exactly what I was looking for. Might not be the best way but it is good for now. Still cannot bevel one edge and extrude at the same time.

    Good for now.

    Joe L.



  3. #3
    Member
    Join Date
    Apr 2009
    Location
    usa
    Posts
    3376
    Downloads
    0
    Uploads
    0

    Default Re: Part , slice or section a 3D part

    A .bbcd file and we can probably figure it out

    You have to .zip it to upload it



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Part , slice or section a 3D part

Part , slice or section a 3D part