Using bobcad v28 and cannot find a way to break apart a 3D object. I have a part that is too big to 3D print so I need to break it apart into 4 sections. There must be a way to do this. If not, I could draw the part into 4 sections but I then cannot figure out how to bevel only the outside edge of a circle.
I used the extrude boss and draft angle to build the complete circle but I cannot bevel the outside edge when it is in quarters?
I got it! I finally found out how to work the solids-split commands and got exactly what I was looking for. Might not be the best way but it is good for now. Still cannot bevel one edge and extrude at the same time.