- Lathe micron value parameter
-
Lathe micron value parameter
Hello Everyone,
Is there any parameter which decide Peck Q value required in *1000 multipler ( in micron )
if i input Q = 1.2 but fanuc controller required Q= 1200
Same for G76 cycle P= thread depth required in *1000 multipler
Parameter Number ?
-
-
Re: Lathe micron value parameter
yes i am looking for information on these parameters. Hope to find the most suitable answer soon! wuxiaworld
- Lathe micron value parameter
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules