Tree Journeyman Overlimit switch

[baprmach]

Hello! I am having an overtravel alarm, which I thought was in my z axis because the wires were bent almost to the point of breaking. I have checked voltagesl on the overtravel side and I'm getting zero volts in the switch and at the terminal inside the enclosure. Is that normal? Is there a way to bypass the overtravel side? Any help with figuring this out would be greatly appreciated!

[machinehop5]

...there should be a way to Jog off the limit switches..an Over Travel button in the Cabinet some where or by Holding the start button ON than Jog off the limit......restarting/resetting the control first sometimes 1st.

DJ

[baprmach]

...there should be a way to Jog off the limit switches..an Over Travel button in the Cabinet some where or by Holding the start button ON than Jog off the limit......restarting/resetting the control first sometimes 1st.

DJ

I've jogged off of it, and have taken the switch out. It still comes up with the error of oversight. All 3 axes are away from the limit switch.