Reply with Quote...turn up the Radio vs the noise??
Dynapath 40--is good running?
Journeyman 250 X axis noise
Just purchased this mill and have no experience with Tree or Dynapath 40m control. I do have the manuals which are helpful and I’m kind of learning things as I go. I’ve found that when I jog the X axis in fast or rapid mode I’m getting a rather annoying high pitched squeal. I’m concerned it may be due to a dry ball nut. This machine of course has the automatic lube system but I don’t know of any way to confirm if the nut is receiving lube? Any ideas what could be causing the noise and what I can check? I thought it may also be the screw end bearings but haven’t had time to investigate.
The spindle likewise is making a rattle noise occasionally when decelerating. I’m guessing bearings are likely the culprit there.
Thanks for any insight offered!
Dan
Similar Threads:
Re: Journeyman 250 X axis noise
...turn up the Radio vs the noise??
Dynapath 40--is good running?
Re: Journeyman 250 X axis noise
Originally Posted by machinehop5
It’s running yes, not sure how well yet as I’ve only done simple MDI commands. I bought this mill knowing it would need some TLC but the fact that it’s fault free to begin with is a bonus.
Re: Journeyman 250 X axis noise
Found the source of the squeak / screech in the X axis. I removed the table shroud for cleaning and inspection and the noise is gone. It must have a non factory bend in it somewhere. TG it wasn’t the screw and bearings.
